Ibrahim, Gusri and Bagus, Purnomo and Arinal, Hamni and Suryadiwansa, Harun and Yanuar, Burhanuddin (2018) The machined surface of magnesium AZ31 after rotary turning at air cooling condition. Materials Science and Engineering, 344 (012004). pp. 1-10. ISSN 1757-899X
|
Text
Akhyar_2018_IOP_Conf._Ser.__Mater._Sci._Eng._344_012004.pdf Download (1MB) | Preview |
Abstract
Magnesium is a lightweight metal that is widely used as an alternative to iron and steel. Magnesium has been applied in the automotive industry to reduce the weight of a component, but the machining process has the disadvantage that magnesium is highly flammable because it has a low flash point. High temperature can cause the cutting tool wear and contributes to the quality of the surface roughness. The purpose of this study is to obtain the value of surface roughness and implement methods of rotary cutting tool and air cooling output vortex tube cooler to minimize the surface roughness values. Machining parameters that is turning using rotary cutting tool at speed the workpiece of (Vw) 50, 120, 160 m/min, cutting speed of rotary tool of (Vt) 25, 50, 75 m/min, feed rate of (f) 0.1, 0.15, 0.2 mm/rev, and depth of cut of 0.3 mm. Type of tool used is a carbide tool diameter of 16 mm and air cooling pressure of 6 bar. The results show the average value of the lowest surface roughness on the speed the workpiece of 80 m/min, cutting speed of rotary tool of 50 m/min, feed rate of 0.2 mm/rev, and depth of cut of 0.3 mm. While the average value of the highest surface roughness on the speed the workpiece of 160 m/min, cutting speed of rotary tool of 50 m/min, feed rate of 0.2 mm/rev, and depth of cut of 0.3 mm. The influence of machining parameters concluded the higher the speed of the workpiece the surface roughness value higher. Otherwise the higher cutting speed of rotary tool then the lower the surface roughness value. The observation on the surface of the rotary tool, it was found that no uniform tool wear which causes non-uniform surface roughness. The use of rotary cutting tool contributing to lower surface roughness values generated.
| Item Type: | Article |
|---|---|
| Subjects: | T Technology > TJ Mechanical engineering and machinery |
| Divisions: | Fakultas Teknik (FT) > Prodi Teknik Mesin |
| Depositing User: | Dr Gusri Ibrahim |
| Date Deposited: | 26 Jun 2018 02:44 |
| Last Modified: | 26 Jun 2018 02:44 |
| URI: | http://repository.lppm.unila.ac.id/id/eprint/7694 |
Actions (login required)
 |
View Item |